|
Spra' Strip Clear Coat Remover |
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
General guidelines for use: Spra' Strip Clear Coat Remover does not contain acid, but it can irritate and dry the skin and so we recommend wearing rubber gloves when working with this product. No medical treatment is required unless the remover is consumed or comes in contact with the eyes. Always work in a well ventilated area where the temperature is above 50 degrees F. and below 95 degrees F. Never work in direct sunlight because the heat from the sun will dry the remover too quickly which will waste product. Never work in the wind because the remover may be carried to surfaces that you do not wish to strip. Make certain that the surface on which you are working is cool, not hot. A garage with the door or window open is a prime location in which to work on a stripping project. When finished working for the day, return any remaining product to the can. Wash the empty spray bottle with denatured alcohol, rubbing alcohol, or hot water. Replace the sprayer head and spray any remaining remover onto a safe surface. This will extend the life of the chemical resistant bottle.
Often, cans
are kept in areas that are subject to dampness and over time cans may
deteriorate. Unused Spra' Strip can be transferred to a glass container
which should be clearly marked with its contents. This will prevent any
moisture or dampness causing an environmental stress on the integrity of
the metal container. |
|||||||||||||||||||||||||
 |
|
Contact:
Webperson
with questions
or comments about this web site.
To
order by phone call 800-343-9763 |
Last
modified:
10/31/09
All PRICES QUOTED IN U.S. DOLLARS